Today's session:
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030211.JPG)
Stn 3 bulkhead glued in, along with two deck beams that the headlining will be glued to.
Berth/galley front glued and wedged to stn 3 bulkhead. Little glue should appear on this face.
Berth front glued to deck stringer (berth front outside) with 11.75mm overlap at model scale, 50mm overlap at full size.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030219.JPG)
Looking vertically down at stn 6, to check that the slots in the berth/cockpit front are lined up with the edge of the deck stringer.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/thumbnail/P1030215.JPG)
Inside the galley locker, excess glue extrudes out of the joint.
Fillet inside the galley locker.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030217.JPG)
Scrap 2mm HDPE laid in where the companionway slide will run, to keep the slot at constant width and clear of glue.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030220.JPG)
The main cabin headlining glued in place on the deck beams.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030221.JPG)
Looking forward at the headlining, with the 2mm HDPE sheet keeping the slot clean and at constant width.
![](/resources/MemberAlbums/2757889/SibLim%207%20metre%20-%20model%20at%201_4.25%20scale/preview/P1030222.JPG)
The final result of one assembly session, with stn 3 bulkhead, both cockpit/berth fronts and main cabin headlining glued in, stn 1 and stn 2 bulkheads ready to glue in next.