I was beginning to wonder if I would ever get to this stage, but first top coat on one side.

Sanding progresses, and one side of the hull is almost done. Just two small patches to go. I have been using the random orbital sander for most of it but I have had to use the belt sander on a few stubborn bits. Using the belt sander requires a very zen headspace...a slip in concentration and you've gouged the ply.

Just letting you know...

I ain't dead, and neither is the project. I just had a few other things in life to take care off, and today is way too miserable to do sanding. :)

Bonsoir

Bravo for the surgery. Be carefull for the recovery.

Amicalement

Eric

Annie has explained this several times. Her method is taken from the Gudgeon Brother’s manual on West epoxy. It goes something like this.

• 1.      Start with dry-fitting the item with wooden screws.
• 2.      Mark the position of the item carefully.
• 3.      Remove the item and drill up the screw holes to about double diameter.
• 4.      Fill the holes thoroughly with epoxy. If the surface is vertical, I would first brush epoxy resin thoroughly in the holes and then squeeze in thickened epoxy afterwards
• 5.      Put the item back into position and drill holes for the screws again. Actually, Gudgeon Brothers recommend using machine screws as wooden screws, that is without using nuts (if the plywood/wood is thick enough).

Anyway, this prevents water from entering the endgrain of the ply.

In hot and humid conditions, it appears to be the only alternative.
Personally I would remove the two screws on one window on Redwing 2 after a couple of weeks of hardening the glue. Then I would just seal the screw holes with epoxy. If the window doesn’t come loose during the next two weeks, I would do the same to the rest of the windows.

No guarantees...

Arne